Metal roofing
Architectural shingles
Tile roofing
GAF
Owens Corning
Flat & low-slopeFree roof inspection with deck photos before we talk money - GAF and Owens Corning certified installation
CertainTeed Metal Roofing in Summerlin: What to Know First
Metal roofing work on Summerlin homes typically runs $9,800 to $24,500 for a full standing seam system on a 2,000-square-foot roof, and most repairs land between $450 and $2,200. As an independent CertainTeed service provider, we handle the metal roofing side of a CertainTeed roof – standing seam, metal shingle, corrugated, and coating work – and we’ll give you a written, line-item estimate before anyone touches your roof. If you’ve got a CertainTeed metal roof that’s leaking, oil-canning, or just past its coating, call (844) 951-4545 and a live person picks up, day or night.
This page is for Summerlin homeowners who already own a CertainTeed metal roof – or are pricing one – and want to know what actually goes wrong with it, what it costs to fix, and who’s going to show up. Free second opinions on any written estimate you’re holding.
How CertainTeed Products Fail – and How We Fix Them
Metal roofing is a smaller slice of CertainTeed’s catalog than shingles, so a lot of roofers treat it like generic sheet metal. Here’s what we actually see on CertainTeed metal roofs around Summerlin, and what we do about it.
- Oil-canning on CertainTeed standing seam panels. Those wavy ripples across a flat panel aren’t a defect and they don’t leak – they happen when a wide pan panel expands in the desert sun and the metal has nowhere to go. What matters is whether the clips were set to allow that movement. We check clip spacing and panel attachment first, because a panel that’s screwed tight instead of clipped can pull its fasteners and open a seam.
- Fastener back-out on CertainTeed metal shingle and corrugated systems. Summerlin sits in a high-heat, low-humidity swing – afternoons over 100 degrees and cool nights. That cycling works on exposed fasteners, and on CertainTeed’s corrugated and metal shingle profiles the screws walk up out of the deck over time. We pull the loose ones, check the washers, and reset or replace with the correct gasketed fastener, because an over-driven screw flattens its neoprene washer and that’s where the leak starts.
- Chalky, fading finish on CertainTeed coated panels. The factory finish on a coated metal panel breaks down in Summerlin’s UV load faster than homeowners expect, especially on south- and west-facing slopes. When it goes chalky, a coating recovers it before the substrate is exposed. We prep, prime, and recoat rather than replacing panels that still have years of steel left in them.
- Granule loss and edge curl on CertainTeed metal shingle accents. Some Summerlin homes mix a metal shingle field with CertainTeed’s metal accent profiles, and those small pieces take the worst wind and sun. Lifted edges and lost granules at the hip and ridge are common. We re-seat or replace the individual pieces and re-flash the transitions so the fix holds through monsoon season.
- Seam and penetration leaks on standing seam. The panels themselves rarely fail – the seams, pipe boots, and wall transitions do. On CertainTeed standing seam we check every seam foot by foot and re-flash penetrations with the right metal-compatible materials, not tar, because tar on a metal roof traps water and makes the next repair worse.
Two things you won’t read on CertainTeed’s own site: wide-pan oil-canning that shows up a few summers after install usually traces back to clip technique, not the panel, and a Summerlin roof can look fine on top while the underlayment under a metal field is already cooked from attic heat. We look underneath, not just at the surface. Same goes for a GAF or Owens Corning roof elsewhere on the property – we handle those too.
Styles & brands we work with
- Architectural shingles
- Metal roofing
- Tile roofing
- GAF
- Owens Corning
- Flat & low-slope
Our CertainTeed Metal Roofing Process
- 1
You call, a real person answers. No call center, no voicemail. Bill will set a time that works and there’s no trip charge inside our own county.
- 2
We get on the roof and diagnose. We walk the panels, check fasteners, seams, flashings, and the underlayment, and photograph what we find so you’re not taking our word for it.
- 3
We decide on parts – OEM or quality aftermarket. Sometimes a CertainTeed-matched component is the right call to keep the panel system consistent; sometimes a quality aftermarket fastener or flashing does the same job for less with no compromise. We tell you which and why, and you get the deck photos before we talk money.
- 4
We do the work. Bill and his crew – background-checked, and Bill’s own sons on the roof with him – pull the panels or shingles as needed, re-flash, re-seat, and match the existing system.
- 5
We test it. We run water at the repair and check the seam or penetration from below before we call it done.
- 6
We back it in writing. Every job carries the 90-Day Done Right Promise, and one call brings Bill back if it isn’t right.
See the difference
Before
After
Before
After
Before
AfterWhat CertainTeed Metal Roofing Costs in Summerlin
Here’s honest Summerlin pricing, not a phone number that changes at the door.
| CertainTeed metal roofing job | Typical Summerlin range |
|---|---|
| Metal roof repair (seam, fastener, flashing) | $450 – $2,200 |
| Metal roof coating on existing CertainTeed panels | $3,500 – $7,800 |
| Standing seam metal roof, full install (2,000 sq ft) | $9,800 – $24,500 |
| Metal shingle or corrugated install (per square) | $650 – $1,100 |
| Panel section replacement (per panel) | $300 – $900 |
What moves the price: roof pitch and access, how many panels come off to reach a hidden problem, whether the underlayment is still good, and the panel width and gauge you want. A steep two-story roof on the edge of the Summerlin foothills takes more setup than a single-story ranch, and that shows up in labor, not parts. Standout perk: your free estimate is free, with no trip charge inside our own county, and $40 off any repair over $200. Call (844) 951-4545 to schedule yours – you’ll know the number before anyone touches your roof.
Why Summerlin Homeowners Call Shepherd & Sons Roofing Summerlin for CertainTeed Work
Most folks who call us here in Summerlin got burned once by an out-of-state outfit that quoted one price on the phone and another at the door. We’re the roofer your neighbor used. Locally owned and owner-operated from the same address since 1996, proudly serving our communities for over 29 years, with Bill’s name on the truck and a license number you can look up. A roof is measured in squares – ask any bidder how many they counted, and we’ll show you ours.
Our technicians have up to 30 years of experience, and we know CertainTeed metal systems as well as the shingle side of the catalog. And if a repair turns out to be a GAF or Owens Corning question instead of a CertainTeed one, we’ve set those too – name the system and we’ve likely worked it. The 90-Day Done Right Promise is in writing on every roofing job, and a live person answers the phone 24/7, including nights and weekends after a storm. Senior and veteran discount of 10% is always available, and we’re glad to give a free second opinion on any written estimate you’re holding – no hassle, no pressure.
FAQs
Not automatically – CertainTeed’s warranty hinges on proper installation and use of compatible components, so a repair done right generally keeps coverage intact. What can void it is a wrong fastener, an incompatible sealant, or a sloppy seam. We work warranty-safe on CertainTeed metal and tell you upfront if something we’d do affects coverage. Call (844) 951-4545 for a free estimate and a straight answer.
Usually, yes – we source CertainTeed-matched panels and components, and where a quality aftermarket fastener or flashing does the same job for less, we’ll say so. Match matters most for visible panels where color and profile show; for hidden fasteners, the right spec matters more than the name on the box. Call (844) 951-4545 and we’ll tell you what your roof actually needs.
If the panels are sound and it’s a seam, fastener, or flashing problem, repair is almost always the smarter money – typically $450 to $2,200 versus a full replacement. Replacement makes sense when the finish is gone across the whole field, or oil-canning traces to a bad clip install the whole roof shares. We’ll show you photos from the roof and let you decide. Free estimate at (844) 951-4545.
We answer the phone 24/7 with a live person, so call and we’ll set the soonest slot that works – and a leak after a monsoon gets moved up. There’s no trip charge inside our own county, so an estimate visit costs you nothing. Call (844) 951-4545 to get on the schedule.
No – we’re an independent CertainTeed service provider, not affiliated with or authorized by CertainTeed. What we offer is the experience: technicians with up to 30 years of work on metal systems, warranty-safe practices, and the written 90-Day Done Right Promise behind every job. Call (844) 951-4545 for a free estimate.
When the metal roofing on your Summerlin home needs a real look, call Shepherd & Sons Roofing Summerlin at (844) 951-4545 for a free estimate. A live person answers, we show you the deck photos before we talk money, and you’ll know the number before anyone touches your roof.
Written by the team at Shepherd & Sons Roofing Summerlin, serving Summerlin and nearby areas.